Commercial Boiler Heating System Fuel Economizer

I-con - UBE 1440 is a microprocessor-based, fuel-saving control for Steam or Hydronic boiler heating systems. It reduces fuel consumption, wear on parts, flue emissions and electrical usage, when installed on most new or existing gas or oil burners. UBE 1440 uses DCM technology to save energy by adjusting the burner run pattern to match the system’s “heat load.” Its action is similar to the industry accepted method of “outdoor-air temperature reset control,” but does not require an outdoor-air temperature sensor or the need to profile the building in order to adjust the “reset” controller properly. UBE 1440 determines the “heat load” by using an easily installed steam pressure transducer or strap-on temperature sensor that monitors the boiler’s steam pressure and \ or out-flow water temperature and the rate that the heating medium temperature or pressure is changing.

Features

• For systems 1 million BTU and larger
• Dynamic Cycle Management
(DCM) technology reduces fuel consumption—typically 10% to 20%
• Touch Screen interface & display shows fuel consumption savings, operating modes, system diagnostics and operating temperatures
• Wi-Fi function available

• Short payback period—typically 12
to 24 months
• Increased savings without
replacing or upgrading costly
system components
• “State-of-the-art” microprocessor based
control
• Easily installed sensor(s)
(up to 3 sensors can be used)

• Simple installation by qualified installer
• After commissioning, no follow-up visits are required
• Maximum efficiency year-round
• Reduces maintenance and
extends boiler life
• Fail-safe operation
• Guaranteed to reduce fuel
consumption
• 10-year replacement warranty for breakdowns or defects